Pahū ʻo Shenhai
Kūʻai kekahi poʻe i nā kukui uila pahū, e hōʻea maʻamau me ka wehe ʻana. Mālama kēia i ko lākou kūpaʻa i ka hiki ʻana i ka wahi e hele ai, ka pale ʻana i ka hoʻoneʻe ʻana o nā mea ma muli o ke kuʻi transit. Inā hui pū ʻia, Hiki i nā mea hoʻohana ke hoʻohana pono iā lākou me ka nānā ʻole ʻana i nā ʻāpana, hiki ke alakaʻi i ka hoʻohana pono ʻole a me ka emi ʻana o ka hana.
Nā kuhikuhi hoʻohana:
1. Installation Preparation:
Determine the light’s installation location and method based on actual needs at the work site. Prepare a three-core cable (Φ8–Φ14 mm) of the necessary length, measured from the light socket to the power source.
2. Wiring the Ballast:
Open the ballast’s end cover and loosen the cable gland at the cable entry point. Thread the light’s cable and the power wire through the gland into the ballast to the terminal block, connect and secure them, then tighten the cable gland and fasten the ballast’s end cover.
3. Mounting:
Install the light fixture and ballast at the predetermined location. Connect the other end of the ballast’s input cable and power up with a 220V source for illumination.
4. Adjusting Orientation:
Loosen the bottom screw of the lamp bracket to rotate it 360° left or right to adjust the lighting direction. Loosen the screws on the sides of the bracket to adjust the lamp head’s angle up or down as needed for optimal illumination, then retighten the screws.
5. Replacing the Bulb:
To replace the bulb, use an appropriate screwdriver or tool to insert into the holes on the two protruding parts of the front cover. Rotate inwardly to remove the cover, replace the faulty bulb with a new one.