Shenhai ntsa̲ explosiones
Ya cajas control ntsa̲ explosiones ar utilizan principalmente da controlar ya cajas NTHEGE sistemas ya iluminación ne ya cajas ntsa̲ explosiones ya sistemas suministro energía. Ar xi personalizar ko 'na'ño materiales ar carcasa nä'ä mä ya requisitos ar ar usuario, Comúnmente utilizando aleación aluminio, Asero inoxidable, ne materiales aislantes raros. Gi cajas ar control ar emplean principalmente jar entornos peligrosos ko ya explosivos ne incluyen componentes komongu ar disyuntores, Contactores, Relés térmicos, Convertidores, Ya señalización, botones, etc., ko marcas componentes seleccionables nä'ä mä ya preferencias ar usuario.
1. Nxoge ar instalación, Inspeccione ya piezas ne componentes, nja'bu ngu ya dimensiones, pa nu'bu omisiones.
2. Ya ar instalar ar caja control, Evite golpear, Zu̲nt'i, wa rascar ya superficies ntsa̲ explosiones pa xi hño da ja da permanezcan lisas.
3. The box should not be struck with screws or nuts, nor should inappropriate screwdrivers and wrenches be used during installation.
4. Prior to assembling the electrical components in the control box, conduct a pressure test as required, maintaining a pressure of 1MP for 10-12 sobras.
5. When assembling the electrical parts of the box, ensure the caja ntsa̲ explosiones is installed in the correct location and secured firmly to guarantee stability.
6. Mark the assembled box with a marker, ensuring clear and complete line numbering. Pay attention to the order of colors and wire diameters when wiring to prevent confusion and ensure clarity.
7. 'Me̲fa ar instalación, perform a trial run as per the electrical design requirements.
8. Tighten the cable bundles and install the trunking covers after the trial run, checking that the ground wire is properly connected.
9. Before tightening the box cover, evenly apply 0.1-0.3mm3# calcium-based grease to the explosion-proof surface of the box to prevent corrosion and water ingress.
10. When fastening the cover, use a tightening torque of 18N,m, applying screws in a symmetrical, progressive, and uniform crosswise manner.
11. 'Me̲fa ar instalación, tighten the box cover with a plug gauge and check the explosion-proof gap, ensuring the maximum gap is no less than 0.1mm.
12. Once assembly is complete, clean the surface of the explosion-proof box. Appropriately package it with foam to prevent damage to the box’s structure and surface coating during transportation and installation, and to avoid water ingress.